Quilt calculators
Sashing a quilt
Type how many blocks you have across and down, their finished size, the finished sashing width and whether you want cornerstones. You get the strips and squares to cut, the fabric for each, and the size of the finished top.
Published Nov 12, 2026
Worked example
- Strip cut width 2 + ½ = 2½ in, length = block 12 + ½ = 12½ in
- Strips: 4 × 6 across + 5 × 5 down = 49
- Cut 12½ in strips across the width, 16 pieces each: 4 strips = 1½ yd
- Cornerstones: 5 × 6 = 30 squares
Finished top with 2 in sashing and cornerstones
| Layout | 10 in blocks | 12 in blocks |
|---|---|---|
| 3 × 4 | 38 × 50 in | 44 × 58 in |
| 4 × 5 | 50 × 62 in | 58 × 72 in |
| 5 × 6 | 62 × 74 in | 72 × 86 in |
| 6 × 7 | 74 × 86 in | 86 × 100 in |
| 7 × 8 | 86 × 98 in | 100 × 114 in |
What sashing does for a quilt
Sashing is the grid of strips that separates the blocks. It gives each block room to be seen on its own, keeps busy blocks from running into each other, and stretches a small set of blocks into a bigger quilt. Twenty 12 in blocks set side by side make a 48 × 60 in top. With 2 in sashing between and around them, the same blocks make 58 × 72 in.
It also forgives a little. Blocks that are not quite the same size are easier to line up against a strip than against each other, though a block that is ¼ in off still needs fixing before you sew.
Counting the strips
The calculator frames every block, so sashing runs around the outside edge as well as between the blocks. Each row of blocks has a strip above and below it: with 5 rows that is 6 lines of strips, each holding 4 strips, so 24. The vertical strips sit between and beside the blocks in each row: 5 per row, 5 rows, 25 more. That is 49 strips, each cut ½ in longer and ½ in wider than it finishes, 2½ × 12½ in.
Cornerstones fill the spots where the lines cross, one for every crossing: 5 × 6 = 30 squares of 2½ in.
A smaller example
Twelve 10 in blocks, 3 across and 4 down, with 2 in sashing: 3 × 5 + 4 × 4 = 31 strips of 2½ × 10½ in. A 42 in strip cut 10½ in tall gives 16 of them, so 2 strips, 21 in of fabric, ⅝ yd. The cornerstones are 4 × 5 = 20 squares, which fit in 2 strips of 2½ in, ¼ yd. The top finishes at 38 × 50 in, close to a crib quilt; check the crib quilt size page if that is the plan.
Cornerstones or long strips
Cornerstones in a contrasting fabric add a small grid of squares that marks every corner, and they make alignment easy, because each crossing is a seam you can pin. Choose No (long strips) and the calculator cuts short strips only between the blocks in each row, then long strips that run the full width between the rows. Long strips look calmer and use one fabric, but you have to mark where each block seam falls so the columns line up from row to row.
Sew short strips and blocks into rows first, then join rows with the long strips or the cornerstone rows between them.
Planning from the other end
If you start from a bed size instead of a block count, the quilt block calculator takes a sashing width and tells you how many blocks fit. Then come back here for the cutting list. A wider sashing reaches a target with fewer blocks; the table shows that 2 in sashing alone turns a 4 × 5 set of 12 in blocks from 48 × 60 in into 58 × 72 in.
Questions
How wide should quilt sashing be?
There is no single rule; the table above uses 2 in finished. Narrow sashing reads as a thin line, wider sashing as a frame, so audition a strip beside a block before you cut.
Do I need cornerstones in sashing?
No. They are a design choice that also helps line up the blocks. Without them you cut long strips between the rows.
How much does sashing add to a quilt?
One sashing width for every block plus one more. With 4 blocks across and 2 in sashing, the width grows by 5 × 2 = 10 in.
How we calculate: every rule and rounding step is on our method page; where the sizes and facts come from is on sources.
broiderer.com is not affiliated with any fabric, thread or sewing machine brand. Last reviewed November 2026.