Embroidery stitches
Stem stitch
Stem stitch is an outline stitch where each new stitch starts halfway along the one before and lies slightly to its side, so the line twists like a fine rope. The numbered diagrams below show it step by step.
Published Nov 6, 2026
01Come up at 1 on the line and go down at 2, one stitch length along it.
02Come up at 3, halfway back along that stitch and just below it. Keep the working thread below the needle.
03Go down at 4, half a stitch length past 2, so this stitch is as long as the first. Each new stitch starts halfway along the last one.
04Keep going the same way. The overlapping stitches twist into a fine rope that bends round curves.
Key:stitches already madethis stepneedle under the fabric (dashed)
How many strands of floss
| Strands | Line it makes |
|---|---|
| 1 strand | very fine lines, lettering, small details |
| 2 strands | fine outlines; the usual choice on 14 count fabric |
| 3 strands | medium lines, most surface embroidery |
| 4 to 6 strands | bold lines and texture; harder to pull through tight weaves |
Six-strand cotton floss comes in skeins of 8 m (about 8.7 yd). Separate the strands one at a time and lay them back together for a smoother line.
What stem stitch is used for
As the name says, it is the stitch for flower stems, tendrils and vines. It is just as good for outlining shapes and for any line that bends, and the twisted look gives a line more body than a plain backstitch.
Worked in rows packed close together, it also fills a shape. Each row follows the outline, so the filling picks up the curve of a leaf or petal.
Thread and needle
Use six-strand cotton floss and separate the strands you need. The strands table above is the guide: two strands for a fine outline, three for a medium line that shows the rope twist well, four or more for a bold stem.
An embroidery (crewel) needle is right here: sharp, with a long eye for several strands. Check hand sewing needle sizes if you are unsure which number to use.
Tension and common mistakes
The one rule that matters most is to keep the working thread on the same side of the needle for the whole line. Working left to right, right-handed stitchers keep it below the needle, as in step 2. Change sides partway and the twist flips, which shows as a kink in the rope.
Turning the hoop changes which side is which. If you turn the work to stitch right to left, the thread goes above the needle instead.
- Stitches of different lengths: the rope looks lumpy. Aim for every stitch the same size, with each one coming up halfway back along the last.
- Drifting off the line: come up right next to the line, not a thread or two away from it.
Stem stitch vs. similar stitches
Outline stitch is worked the same way with one change: the thread is held above the needle instead of below. The overlaps then slant the other way and the line looks smoother and less corded. Alternate the two, one stitch each, and you get cable stitch.
Split stitch also comes back into the previous stitch, but it comes up through the middle of the floss instead of beside it, so the line looks like a tiny chain. Turn either stem or outline stitch over and the back looks like a row of backstitch.
Working curves and points
Stem stitch follows curves better than most line stitches. On a tight curve, shorten the stitches; long stitches cut across the bend and the line goes flat at that spot.
At a sharp point, such as the tip of a leaf, end the line with a stitch right at the point and take the thread to the back. Start the next side as a new line rather than trying to pivot the twist round the corner.
Variations
Whipped stem stitch wraps a second thread over the finished line without piercing the fabric for a smoother, rounder cord. Portuguese knotted stem stitch adds small wraps as you go, giving a knobbly, textured stem. For a filling, work rows of stem stitch side by side, starting each row at the same end so the twist runs the same way.
Questions
What is the difference between stem stitch and outline stitch?
Only the side the thread is held on. In stem stitch the thread stays below the needle when working left to right; in outline stitch it stays above, so the overlaps slant the other way.
Where do I bring the needle up in stem stitch?
About halfway back along the stitch you just made, right beside it on the thread side. All stitches should be the same length, so each one overlaps the last by half.
How many strands of floss for stem stitch?
Two or three strands of six-strand floss suit most stems and outlines. Use more for a bold line.
Why does my stem stitch look twisted the wrong way?
The working thread changed sides of the needle, usually after the hoop was turned. Keep it on one side for the whole line.
How we calculate: every rule and rounding step is on our method page; where the sizes and facts come from is on sources.
Traditional stitch. Step diagrams drawn by broiderer.com.
broiderer.com is not affiliated with any fabric, thread or sewing machine brand. Last reviewed November 2026.